O'Neill Basic Skins Short Sleeve Rash Guard - White - 44

UPF 50+ UV protection Spandex 4-way stretch Boardshort connector Rash protection Quick dry Slim fi...

Currently unavailable

Child Size UK
Colour
Waist Size UK
Material

Currently out of stock

This product is not available at the moment. Check back later.

Product Information

Full details

The O'Neill Basic Skins Short Sleeve Rash Guard is designed for water sports enthusiasts seeking reliable sun protection and comfort. Its key benefit is UPF 50+ UV protection, shielding skin from harmful rays during extended outdoor activities. A potential caveat is its slim fit, which may not suit everyone's preference for looser apparel. This rash guard offers UV protection, quick-drying properties, and 4-way stretch for unrestricted movement in and out of the water.

All features

ColourWhite
MaterialSatin
Waist Size UK44
BrandO'Neill

Extended Product Information

FAQs

What does UPF 50+ mean?

UPF 50+ means the fabric blocks over 98% of the sun's harmful ultraviolet radiation (both UVA and UVB) when the garment is worn as intended.

Can I wear this for swimming in a chlorinated pool?

Yes, you can wear it in a chlorinated pool. However, it's important to rinse it thoroughly with fresh water immediately after swimming to remove chlorine, which can degrade the fabric over time.

How do I know if I have the right size?

The rash guard should fit snugly against the skin without being uncomfortably tight. It should allow for full range of motion in your arms and torso. Refer to the brand's sizing chart for specific measurements.

Is this rash guard suitable for cold water?

This rash guard is primarily designed for sun protection and does not offer significant thermal insulation. For cold water, you would need a wetsuit or a thicker neoprene top.

How often should I replace my rash guard?

Rash guards typically last for several seasons with proper care. Replace it when you notice significant degradation in fabric quality, loss of elasticity, or reduced UV protection.

Can the boardshort connector be removed?

The boardshort connector is typically sewn into the rash guard and is not designed to be removed. It's an integrated feature for a more secure fit.

Troubleshooting

Rash guard feels too tight or difficult to put on

Ensure the garment is completely dry. If wet, try putting it on in a damp state or have someone assist you. The slim fit is designed to be snug; try stretching the fabric gently before putting it on.

Sunburn still occurred despite wearing the rash guard

Verify that the rash guard covers all exposed skin. Check if the fabric has degraded over time (e.g., pilling, thinning). Ensure it was properly rinsed and dried after use, as salt or sand residue can affect fabric performance. Reapply sunscreen to any uncovered areas.

Boardshort connector loop broke

Contact O'Neill customer support for potential replacement options or repair advice. Avoid forceful tugging on the loop.

Pros and Cons

Pros

  • Excellent UPF 50+ sun protection.
  • High degree of flexibility and freedom of movement.
  • Dries quickly, enhancing comfort after swimming.
  • Reduces skin irritation from board contact.
  • Secure fit with boardshort connector.

Cons

  • Slim fit may be too restrictive for some users.
  • Primarily focused on sun protection, offers minimal thermal insulation.
  • Can be challenging to put on when wet due to the snug fit.

Setup, Compatibility & Care

Setup: This is a ready-to-wear garment. Simply put it on before engaging in water activities. Ensure the boardshort connector loop is attached to your boardshorts for a secure fit.

Compatibility: Designed for use with most boardshorts via the connector loop. Suitable for a wide range of water sports including surfing, paddleboarding, kayaking, snorkeling, swimming, and general beach activities.

Care Instructions:

  1. Rinse thoroughly with cold, fresh water immediately after each use to remove salt, chlorine, and sand.
  2. Hand wash with mild soap if necessary. Avoid harsh detergents.
  3. Do not bleach.
  4. Do not wring or twist.
  5. Lay flat to dry in the shade. Avoid direct sunlight, which can degrade the fabric and UV protection over time.
  6. Do not iron.