Tetrion Easy Spray - 400ml - Green

The Tetrion Easy Spray is touch dry in approximately 10-15 minutes and fully hardened within 24 hours under normal conditions.

While suitable for metal, it's recommended to check if the paint is heat-resistant for radiator applications. For standard metal surfaces, it provides good protection.

It is suitable for a wide range of surfaces including wood, metal, ceramic, and plastic.

Shake the can well before and during use, hold it 20-30 cm from the surface, and apply in steady, overlapping strokes. Avoid spraying too close or too far from the surface.

After each use, invert the can and spray for a few seconds to clear the nozzle. If it becomes permanently clogged, you may need to remove and clean the nozzle, or replace the can.

Yes, this spray paint is designed for both interior and exterior use, offering durable protection against the elements.

For best results, use the paint at room temperature. Performance may be affected if used in temperatures below 10°C.

Ensure the can has been shaken vigorously for at least 2 minutes before use and regularly during application. Check that the nozzle is not blocked. Try holding the can closer to the surface or adjusting the spray distance.

Verify that the temperature is above 10°C. Ensure the paint is applied in thin, even coats rather than one thick layer. Check for humidity levels, as high humidity can affect drying times.

Immediately after spraying, invert the can and spray for a few seconds to clear the nozzle. If a blockage has already occurred, try gently removing the nozzle and soaking it in a suitable solvent, then rinse and dry thoroughly before reattaching.

Ensure the surface was properly prepared: clean, dry, and free of grease, dust, or rust. For certain materials like plastic, consider using a compatible primer before applying the spray paint.