SuperGift.com Spray Paint - Red - 400Ml

The paint is typically dry to the touch within 15-20 minutes and can be recoated after approximately 1 hour. Full curing can take 24-48 hours depending on environmental conditions.

This product is designed for hard surfaces like metal, plastic, wood, and glass. It is not recommended for use on fabric.

For optimal results, especially on porous surfaces like wood or challenging materials like certain plastics, using a primer is recommended. Always ensure the surface is clean and prepared.

It is generally recommended to apply 2-3 thin, even coats for best coverage and durability. Allow adequate drying time between coats.

Coverage can vary depending on the surface and application thickness, but a 400ml can typically covers approximately 1.5 to 2 square meters with a single coat.

Store the can upright in a cool, dry place, away from direct sunlight, heat sources, and open flames. Ensure the cap is securely fitted.

While it adheres to metal, for automotive applications where high durability and specific finishes are required, it's best to use paints specifically formulated for automotive use. This paint is suitable for general repairs or decorative purposes on metal.

Shake the can more vigorously for a longer period. Ensure the nozzle is not clogged. Try spraying a test patch on cardboard. If the issue persists, the nozzle may be faulty.

Ensure the surface was properly cleaned and prepared (e.g., free of grease, dust). Lightly sand glossy surfaces before application. For plastics, consider using a plastic-specific primer first.

Apply paint in thin, even coats rather than one thick coat. Maintain a consistent distance of 25-30cm from the surface. Avoid over-spraying in one area.

Turn the can upside down immediately after finishing and spray for 2-3 seconds to clear any paint from the nozzle. If already clogged, try removing and cleaning the nozzle with a solvent if possible, or replace the nozzle.

Ensure you are applying in a well-ventilated area but avoid excessively hot or windy conditions which can accelerate drying too much. Apply thinner coats.