Best current price£13.47from eBay
Shopping.co.uk recommended and popular offers
eBay£13.47Visit shop box of JCP Fixings M10 x 10L Loose Bolt Shield Anchors
Visit shop
The Range£17.33Visit shop Jcp Construction Products Shield Anchors Projecting Bolt Zyp - M6 X 100 (Box Of 50) - White
Visit shop13 offers from £13.47 - £21.86
View price history by clicking the chart icon.
The JCP Construction Products Shield Anchor Projecting Bolt is an essential heavy-duty fastening solution designed for professionals who require a reliable and secure grip in masonry and concrete environments. It is ideal for structural applications where a firm, permanent hold is paramount, though users should ensure the base material is of sufficient density to accommodate the anchor's expansion mechanism for maximum effectiveness.
| Colour | White |
|---|---|
| Model Part Number | 1427277 |
| Brand | JCP CONSTRUCTION PRODUCTS |
They are designed primarily for masonry and concrete. Performance in soft brick is significantly lower than in high-density concrete.
The drill bit size must match the external diameter of the shield; always refer to the technical specifications provided for the specific anchor model.
No, these are intended for permanent fastening; attempting to remove and reuse them will likely result in a loss of structural integrity.
The ZYP finish offers good corrosion resistance for indoor and sheltered outdoor environments, but it should be avoided in marine or highly corrosive chemical environments.
The hole must be at least as deep as the anchor length, ideally slightly deeper to allow for any residual dust.
The hole may be too large or the anchor is not expanding properly. Verify that the drill bit size matches the manufacturer's specification.
Ensure the hole is completely clear of concrete dust and that the drill hole depth is at least as long as the anchor sleeve.
Do not exceed the recommended torque settings; over-tightening can compromise the steel integrity.
To install, first drill a hole into the concrete or masonry using a hammer drill and a carbide-tipped drill bit that matches the required diameter of the shield. Clean the hole thoroughly of all dust and debris, as trapped dust can prevent the anchor from expanding fully. Insert the shield anchor until the washer sits flush against the fixture, then tighten the nut to initiate the expansion. No specialized maintenance is required after installation, but periodic checks for loose nuts in high-vibration areas are recommended. Ensure the bolt is kept dry if the finish is scratched to maintain its corrosion resistance.
