PVC Wall Flashing for Corrugated Bitumen Sheet Profile - Onduline - BTM-WF

This PVC Wall Flashing is designed for the 95/38 profile, commonly used by brands like BituRoof, Onduline, Coroline, and Gutta.

Yes, it is ideal for roof-to-wall connections, as well as for cladding and other junctions where a watertight seal is required with corrugated bitumen sheets of the correct profile.

The PVC flashing can be easily cut using a sharp utility knife or a fine-toothed saw. Measure carefully before cutting.

It is made of premium quality PVC, which is durable, lightweight, and highly resistant to UV rays, moisture, and corrosion, ensuring a long lifespan without degrading like metal.

Standard DIY tools are sufficient, including a utility knife for cutting, a measuring tape, and a drill with appropriate screw bits for fastening. Roofing screws and washers are also required.

Due to its durable PVC construction and resistance to UV and corrosion, the flashing is designed for long-lasting performance, typically many years, when installed correctly.

While PVC is durable, painting is generally not recommended as it can affect the material's properties or UV resistance. It is designed to be used as-is.

Verify that your corrugated sheets are the 95/38 profile. Ensure the flashing is correctly positioned to overlap the sheets and wall as intended. Check that screws are adequate and correctly fastened.

Inspect the entire length of the flashing for gaps or potential entry points. Ensure all fixings are secure and that the flashing overlaps adequately. Consider applying a compatible sealant along the top edge if there are persistent issues.

This is uncommon with standard UV exposure. Ensure no harsh chemicals were used for cleaning. If degradation is significant, the flashing may need replacement. Check for any specific installation errors that might be causing undue stress.