Barrettine Door Oil - Matt - 1L

No, Barrettine Armourflex Door Oil is specifically designed for interior wooden doors and panels only. It does not provide the necessary protection for exterior elements.

Typically, one or two coats are sufficient. Apply liberally, allow to penetrate for 10-15 minutes, wipe off excess. A second coat can be applied after 4 hours if a deeper finish or extra protection is desired.

Yes, it is suitable for all types of solid wood, including oak, and premium veneers, enhancing their natural tones.

Coverage varies depending on the type and porosity of the wood. A general guideline is approximately 10-12 square meters per liter, but always test on a small area first.

It is not recommended to apply varnish over an oil finish. This product is designed to be a final finish. If you wish to change the finish, the oil would need to be fully removed first.

The Matt finish provides a very low sheen, preserving the natural look of the wood with minimal reflection. The Satin finish offers a slight sheen, providing a subtle glow and potentially a bit more resistance to fingerprints compared to a true matte.

Store in the original, tightly sealed container in a cool, dry place away from direct sunlight and sources of ignition. Ensure the lid is securely fastened to prevent the oil from skinning over.

Ensure excess oil was thoroughly wiped off after application. Apply a further thin coat, working it in well and wiping off all excess. Ensure the surface was properly prepared and sanded evenly beforehand.

Check for insufficient ventilation or excessively high humidity. Ensure the product was applied in a thin, even coat and that all excess was removed. Avoid applying in very cold conditions.

This is natural as the oil penetrates and enriches the wood tone. If a lighter look is desired, consider a different product or test on an inconspicuous area first.

This typically indicates that too much oil was applied or excess was not removed properly. Apply a thin coat of solvent (e.g., white spirit) to a clean cloth and wipe the surface firmly to help dissolve and remove the uncured oil. Allow to dry thoroughly in a well-ventilated area.