Rustins Quick Dry Varnish - Teak 250ml

It is touch dry in approximately 20 minutes and recoatable in 2 hours under normal conditions.

No, this varnish is specifically formulated for interior woodwork only and is not suitable for exterior applications.

Brushes can be easily cleaned with warm soapy water immediately after use.

It provides an attractive satin finish, which is a smooth, low-sheen appearance.

Yes, it is suitable for all interior woodwork applications.

For best results and optimal protection, applying two or three thin coats is recommended.

Yes, it is available in several attractive wood shades, including Teak, Pine, Oak, and Mahogany, all in a satin finish.

Ensure the varnish is stirred thoroughly before and during application. Apply thinly and evenly, avoiding over-brushing. Check that the brush is suitable for water-based varnishes.

Ensure the previous coat was fully dry before applying the next. Avoid applying in excessively humid or cold conditions. Make sure the varnish was not applied too thickly.

The surface may not have been properly prepared. Ensure the wood is clean, dry, and free from contaminants like grease or wax. Previous finishes should be removed or suitably abraded.

Use a high-quality synthetic brush and apply the varnish with long, smooth strokes. Avoid excessive brushing. Allow adequate drying time between coats.