Rocktop Multi-Surface Clearcoat Matt - 1 L

Yes, it is suitable for wooden worktops, providing protection against moisture and heat. Ensure proper application and curing.

Typically, two to three thin coats are recommended for optimal durability, depending on the surface and desired level of protection.

Dries to touch in 1-2 hours, recoatable in 2-4 hours. Full cure takes approximately 7 days.

No, this is a water-based clearcoat and is only recommended for use over water-based paints.

Clean brushes and any spills immediately after use with warm, soapy water.

Coverage varies by surface porosity, but typically around 10-12 square meters per liter per coat.

While durable, it is primarily designed for interior high-traffic domestic use. Extended outdoor exposure may reduce its longevity.

Apply thinner coats, maintain a consistent wet edge, and use a high-quality synthetic brush. Ensure proper surface preparation.

This can occur if applied too thickly or in cold, humid conditions. Ensure adequate drying time and ventilation. If severe, it may require sanding back and reapplication.

Surface was not properly prepared (e.g., dusty, greasy, or damp). Ensure the surface is thoroughly cleaned and dry before application.

This is usually due to insufficient drying time or excessive humidity. Ensure proper ventilation and allow more time for curing. Avoid heavy use until fully cured.