Skullcandy Indy True Wireless Earbuds - Blue - Indy

The earbuds themselves offer up to 4 hours of continuous playback on a single charge. The charging case provides an additional 12 hours, bringing the total playback time to 16 hours.

The earbuds have an IP55 rating, meaning they are resistant to dust, sweat, and water splashes, but they are not fully waterproof and should not be submerged.

To reset the earbuds, place them in the charging case, leave the lid open, and press and hold the touch surface on both earbuds for approximately 10 seconds until the LEDs flash. Then, close the lid and reopen it to proceed with pairing.

Yes, you can use either the left or the right earbud independently for mono audio playback or calls.

The charging case uses a Micro-USB cable for charging.

Gently pull off the existing ear gel and push on a new size until it is securely attached. Ensure a snug fit for optimal comfort, sound isolation, and stability.

Ensure Bluetooth is enabled on your device and the earbuds are in pairing mode (try resetting them by placing them in the case and holding the touch surface for 10 seconds). Make sure no other devices are actively connected to the earbuds.

Check that the earbud is charged and properly seated in the charging case. Try cleaning the charging contacts on both the earbud and the case. Reset the earbuds and re-pair them with your device.

Ensure your device is within range of the earbuds. Minimize potential interference from other wireless devices or physical obstructions. Update your device's Bluetooth drivers if possible. Reset and re-pair the earbuds.

Ensure your fingers are clean and dry when interacting with the touch controls. Try cleaning the touch surface on the earbuds. If the issue persists, try resetting the earbuds.

Verify that the charging case itself is charged. Clean the charging contacts on the earbuds and inside the case. Ensure the earbuds are properly seated in the case.