Simms Guide BOA Wading Boots - UK 6

Turn the dial to tighten. Pull the dial to release and allow the laces to loosen.

The Simms Guide BOA Wading Boots are available with either felt or Vibram® rubber soles.

Rinse the boots with fresh water after each use. Allow them to air dry completely.

Yes, the boots have a TPU outsole plate designed for stud and cleat retention. Ensure you use compatible studs.

Warranty information can be found on Simms' website or by contacting their customer service.

The BOA system is designed to be user-replaceable. Replacement parts are usually available through Simms or authorized dealers. Follow the instructions provided with the replacement kit.

While the boots are durable, rinsing them thoroughly after saltwater use is essential to prevent damage from salt corrosion.

Check for debris in the dial or laces. Clean the system and ensure the laces are properly routed. If the issue persists, contact Simms for repair or replacement of the BOA components.

Adjust the BOA dial to fine-tune the fit. Ensure the laces are evenly distributed and not caught on anything inside the boot.

Check for any punctures or damage to the boot material. Ensure the waders are properly sealed over the boots. If the boots are damaged, repair them with appropriate sealant or contact Simms for assistance.

Make sure you have chosen the appropriate sole type (felt or rubber) for the river conditions. Consider adding studs or cleats if the surface is particularly slippery.