Arranwood Hardwood Faced Plywood - 15mm

The EN636-2 standard indicates that the plywood is suitable for use in humid conditions, offering better moisture resistance than standard interior grades but not intended for continuous external exposure without proper sealing.

While it is rated for humid conditions, for outdoor use or prolonged moisture exposure, it requires adequate sealing with a waterproof finish or paint to prevent damage and delamination.

The nominal size is 915mm x 610mm. Please note that due to the cutting process, the actual cut sheet size may vary slightly due to the loss of blade width.

No, this is a versatile non-structural wood panel. It is suitable for joinery, shelving, and linings, but not for load-bearing applications where structural integrity is critical.

The smooth sanded face can be painted, varnished, lacquered, or covered with laminate. Choose a finish appropriate for the intended use and environment.

The plywood is sustainably resourced from managed forestry operations.

Ensure your saw blade is sharp and suitable for cutting plywood. Consider using a fine-tooth blade and a guide for straighter cuts.

Pre-drill pilot holes slightly smaller than the screw diameter. For extra strength, use wood glue in the pilot hole before inserting the screw.

Lightly sand the cut edges with fine-grit sandpaper. The face veneer is smooth, but edges may require minor finishing.

Ensure the panel is stored flat and not under pressure. Minor warping can sometimes be corrected by carefully weighting it down on a flat surface.