Self Adhesive Film - Sonoma Oak - Brown

While the film is heat-resistant up to 70C, it is generally not recommended for direct contact with hot pots and pans. It's better suited for vertical surfaces like cabinet doors or shelves.

The film is water-resistant but not fully waterproof. It can withstand occasional splashes, but prolonged exposure to water should be avoided.

Gently lift an edge of the film and slowly peel it away from the surface. Use a hairdryer to heat the adhesive if it's difficult to remove.

It is best to apply the film to smooth, flat surfaces for the best results. Textured surfaces may not allow the film to adhere properly.

You will need a measuring tape, scissors or a utility knife, a smoothing tool (or credit card), and a clean cloth.

The film is somewhat flexible, allowing it to be used on slightly curved surfaces. However, it's best suited for flat surfaces for optimal application.

Carefully lift the film and smooth out the bubbles with a smoothing tool or credit card, working from the center outwards.

Ensure the surface is clean, dry, and flat. Try using a heat gun or hairdryer on a low setting to activate the adhesive, or re-apply after cleaning the surface with isopropyl alcohol.

Handle the film with care. Make sure you cut the film accurately before application. If it tears, try to smooth it and consider using an additional piece to cover the tear.