soundcore Liberty 5 Pro - White - Active Noise Cancellation

Place both earbuds in the charging case and leave the lid open. Press and hold the button on the back of the charging case for approximately 10 seconds until the LED indicator flashes three times. The earbuds will then reset and be ready for pairing.

HearID 5.0 analyzes your unique hearing profile through a series of tests within the soundcore app. It then creates a customized EQ setting tailored specifically to your ears, enhancing details and optimizing your listening experience.

Yes, both the left and right earbuds can be used independently. You can take calls or listen to audio with a single earbud.

Connect your earbuds to your device and open the soundcore app. If a firmware update is available, you will be prompted to download and install it. Ensure the earbuds remain connected and charged during the update process.

The earbuds offer up to 8 hours of playtime with ANC off and 6 hours with ANC on. The charging case provides an additional 26 hours of playtime, for a total of up to 34 hours. Fast charging provides 2 hours of playtime from a 10-minute charge.

The 0.96″ touchscreen allows you to cycle through ANC modes, adjust EQ presets, and check battery status without needing to access your phone. Tap or swipe on the screen as indicated within the app for different functions.

The soundcore Liberty 5 Pro earbuds have an IPX5 rating, making them resistant to sweat and light splashes of water. They are not designed for swimming or submersion.

Ensure earbuds are charged and in the case with the lid open. Reset Bluetooth on your device and try again. If issues persist, perform a factory reset by holding the button on the back of the case for 10 seconds while the earbuds are inside.

Check that the earbuds are properly seated in your ears. Clean the ear tips and speaker grilles. Verify volume levels on your device and in the soundcore app. Ensure the correct HearID profile is active.

Ensure a proper seal in your ear canal. Check ANC settings in the soundcore app and ensure it is enabled. Clean ear tips for optimal fit. Update firmware via the soundcore app if available.

Clean the charging contacts on both the earbuds and inside the case. Ensure the case is plugged into a power source. Try a different USB cable and power adapter.

Ensure the charging case is updated and touch controls are enabled in the soundcore app. Clean the indicated touch areas on the case. Restart your connected device.