Setup, Compatibility & Care
Installation is designed for standard single-hole sink configurations. Ensure that your current sink basin has a pre-drilled 35mm diameter hole.
Installation Steps:
- Turn off the main water supply under the sink.
- Remove the old faucet and clean the basin surface of any debris or old sealant.
- Insert the tap body through the sink hole, ensuring the rubber gasket is correctly seated underneath the base.
- Tighten the mounting nut using the provided hardware until secure.
- Connect your hot and cold flexible supply lines to the wall valves.
Care Instructions:
To maintain the silver finish, wipe the tap with a soft, damp cloth after use. Avoid using abrasive sponges or harsh chemical cleaners, as these can dull the metallic finish over time. Periodically check the supply hose connections for tightness.