Pollor 149Cc 4-Stroke Petrol Push Lawn Mower - 41Cm Cutting Width - 45L Grass Bag

This mower requires 4-stroke engine oil. The engine oil volume capacity is 0.5L. Please refer to your user manual for specific oil type recommendations.

Yes, you will need to purchase unleaded petrol separately to fuel the mower.

It is recommended to check the oil level before each use, especially before the first use and after every mowing session.

Please refer to the product's warranty documentation or contact the retailer for specific warranty information, as this can vary.

While the 149cc engine provides good power, it's best to mow dry grass at a higher setting first, then reduce the cutting height for a second pass if needed. Mowing very long or wet grass can strain the engine and affect cutting performance and collection.

This mower is best suited for small to medium-sized gardens due to its push-propel design and 41cm cutting width.

The cutting height is adjusted by selecting one of the three available positions: 25mm, 45mm, or 65mm. Refer to your user manual for the specific mechanism on your model.

Check fuel level, ensure correct fuel type is used. Verify oil level is adequate. Ensure spark plug is properly connected and free from debris. Check if the primer bulb has been pressed correctly. Ensure the safety bar is held down during starting.

Check the cutting blade for damage or dullness and sharpen or replace if necessary. Ensure the cutting height is set appropriately for the grass length. Clean grass clippings from the underside of the deck. Check and clean the air filter.

This could indicate an unbalanced or damaged blade. Stop the engine immediately and inspect the blade. If damaged, replace it. Ensure the blade is securely fastened.

Ensure the grass collection bag is properly attached and not overfilled. Clean any blockages in the discharge chute or within the bag itself. Consider mowing when the grass is drier for better collection.