Ronseal 10 Year Wood Stain - Dark Oak Satin 750ml - RSL10WSDO750

The product is designed to last for up to 10 years, providing protection against weathering and UV damage.

Yes, but the surface must be sound and well-adhered. If the existing finish is flaking or peeling, it must be removed. For best results on previously oiled wood, consider using a primer.

It is suitable for most exterior bare or previously finished wood, including sheds, fences, gates, and furniture.

It is recommended to apply two to three thin, even coats for optimal protection and finish.

Clean brushes and equipment with water immediately after use.

While it offers protection, it is not specifically designed for decking and may become slippery underfoot when wet or may wear faster in high-traffic areas.

Allow at least 4 hours between coats. Drying times can vary depending on temperature and humidity.

Ensure the product was stirred thoroughly before and during application. Apply thin, even coats, avoiding over-brushing. Check for consistent application pressure.

The surface may not have been properly prepared. Ensure the wood was clean, dry, and free from contaminants. Previous oil-based treatments might require a primer.

Drying times can be affected by humidity and temperature. Ensure application occurs in suitable conditions (typically between 10-25°C and low humidity). Avoid applying in damp or cold weather.