Taskar Concrete-In Post Anchor Bracket - Brown

The bracket has pre-drilled holes suitable for standard wood screws. While the bracket itself is robust, the maximum post size will depend on the load requirements of your project and the type of screws used. It's designed to securely hold typical fence posts, pergola, and carport posts.

The bracket features a 220 mm spike. You should dig the hole deep enough to accommodate the entire spike and allow for at least 100-150 mm of concrete below and around it for optimal stability. The total depth will depend on your local building codes and ground conditions.

No, this is a 'concrete-in' anchor and is specifically designed to be set into wet concrete for maximum stability and load-bearing capacity. Using it without concrete will compromise its structural integrity.

A single Taskar Concrete-In Post Anchor Bracket weighs approximately 0.632 kg.

The bracket is designed for installation in solid foundations like concrete or cement sleepers. For soft ground, it's recommended to create a concrete footing first before embedding the bracket.

Each pack contains one Taskar Concrete-In Post Anchor Bracket.

Ensure sufficient concrete was used to fully encase the spike and base. If instability persists, the concrete may not have cured properly or the hole was not dug deep enough. Re-evaluation and potentially re-installation with adequate concrete and curing time is advised.

Verify that standard wood screws are being used. Ensure the timber post is flush against the bracket and pilot holes are drilled if necessary for harder woods. Check that the bracket's pre-drilled holes are clear of debris.

While the epoxy coating offers significant protection, prolonged exposure to extremely harsh conditions or damage to the coating can lead to minor surface rust. Clean the area gently and consider applying a compatible metal primer and paint for added protection, especially if the damage is significant.