Factory Links Swingarm Bearing Kit - Kawasaki KX250 2021-2024

This Factory Links Swingarm Bearing Kit is designed specifically for Kawasaki KX250 models from the 2021 to 2024 model years.

Yes, the kit includes needle bearings, along with all other necessary components like pins, collars, and dust seals for a complete swingarm service.

The pins are made from 52100 High Grade Steel.

The Nitrile Butadiene Dust Seals are crucial for preventing dirt, water, and other contaminants from entering the swingarm linkage and degrading the bearings and pins.

This kit is designed to restore your swingarm to OEM quality specifications, not to provide performance upgrades beyond the original factory design.

Replacement frequency depends heavily on riding conditions and hours. Regular inspection for wear, play, or stiffness is recommended, usually coinciding with other major maintenance intervals or if performance degradation is noticed.

Standard motorcycle maintenance tools are required, including wrenches and sockets. Depending on the press-fit of components, a bearing press or similar tool might be beneficial. Refer to your Kawasaki service manual for specific torque values and procedures.

Ensure all components are correctly aligned and not binding. Check that the collars and pins are properly seated and that all fasteners are torqued to the manufacturer's specifications. Over-tightening can cause stiffness.

Verify that the dust seals were installed correctly and are intact. Contamination from dirt or water is the most common cause of premature bearing failure. Ensure proper lubrication was applied during installation.

Confirm you are using the correct pin and collar combination for the specific location in the linkage. Ensure the swingarm pivot area is clean and free of debris. Gentle persuasion with a rubber mallet may be needed, but avoid excessive force.