Draper Gas/Gasless MIG Welder - 160A

The Draper MIG Welder supports welding wire diameters from 0.6mm to 0.9mm. The best type of wire depends on the material you are welding.

If you are using gas, the appropriate gas will depend on the materials you are welding. For mild steel, a mix of Argon and CO2 is common.

There is a wire speed control knob on the front panel of the welder. Adjust it to control the speed at which the wire feeds through the torch.

The duty cycle is 10% @ 160A. This means you can weld at 160A for 10% of a 10-minute cycle.

The package includes an electrode holder, earth clamp, MIG torch, chipping hammer, wire brush, and face mask.

This welder can weld aluminum, but you will need to use a special welding wire and ensure the correct settings are used.

Replacement parts are available from Draper or your local tool supply store.

Check the power supply and ensure the machine is properly plugged into a 230V, 16-amp outlet. Inspect the power cord for any damage. Check the internal fuse and replace if necessary.

Check the wire spool for tangles. Inspect the wire feed mechanism for obstructions. Ensure the correct size of wire is used (0.6-0.9mm). Adjust the wire feed tension.

Adjust the wire speed and voltage settings. Check for gas leaks (if using gas). Ensure the workpiece is clean and free of rust or contaminants. Check for correct polarity.

Allow the welder to cool down. Reduce the duty cycle by welding for shorter periods. Check for any obstructions to the cooling fan.

Check the earth connection to the workpiece. Ensure the torch is correctly positioned. Inspect the contact tip and nozzle for obstructions. Check the wire feed.