Deluxe Materials Photo Etch Glue - AD-93

It's designed for bonding small, thin photo-etched metal parts onto scale models and other intricate hobby projects where precision is needed.

The glue is fast-acting, typically setting within minutes, but full cure may take longer depending on application thickness and environmental conditions.

While it can work for small plastic parts, it is specifically formulated for photo-etch and may not provide the same strength or properties as a dedicated plastic cement for larger plastic-to-plastic bonds.

It is generally safe for most cured model paints, but it's always recommended to test on an inconspicuous area first, as some thin paints or finishes might be affected.

Wash hands thoroughly with soap and water. If the glue has bonded skin, carefully peel it apart or use a small amount of a hobby solvent on a cloth to help loosen the bond.

Store upright in a cool, dry place with the cap sealed tightly to prevent air exposure and drying. Avoid extreme temperatures.

Check if the tip is clogged. Gently clear any dried glue with a fine needle or hobby knife. Ensure the cap was properly sealed after the last use.

Ensure both surfaces are clean, dry, and free from dust or grease. Apply a slightly more generous, yet still controlled, amount of glue. Allow adequate drying time.

Wipe away excess glue immediately with a damp cloth or a cotton swab lightly moistened with water or a compatible hobby solvent before it fully cures. For dried excess, carefully scrape or sand it away after it has hardened.