Altecnic Thermostatic Mixing Valve - 15mm

A thermostatic mixing valve (TMV) is a device that blends hot and cold water to deliver a safe, consistent, and usable temperature at the point of use. It automatically adjusts the mix if the supply temperatures or pressures change.

The failsafe feature is crucial for safety. If either the hot or cold water supply fails, the valve automatically shuts off the water flow. This prevents dangerous scalding if the cold supply is lost or extreme cold if the hot supply is lost.

This specific model is designed for healthcare premises, hospitals, care homes, and schools, where safety and precise temperature control are essential.

While the valve itself is a component, its correct and safe installation requires specific plumbing knowledge and adherence to standards. Professional installation by a qualified plumber is strongly recommended.

Temperature adjustment is typically performed by a qualified installer during the initial setup. It often involves accessing an adjustment screw or mechanism on the valve itself. Consult the manufacturer's installation manual for specific instructions or have a professional perform the adjustment.

Regular checks for leaks and visible damage are advised. For continued safe and optimal performance, periodic servicing and testing by a qualified professional are recommended, especially in commercial or healthcare settings.

If the hot water supply fails, the failsafe mechanism will shut off the water flow to prevent a sudden blast of cold water.

Ensure the valve has been correctly installed and set by a qualified professional. Check that both hot and cold water supplies are adequate and that there are no blockages. If issues persist, recalibration by a technician may be necessary.

Check all connections for tightness. Internal components may be worn or damaged, requiring professional inspection and potential replacement of seals or the entire valve.

This is a critical safety issue. Do not use the hot water supply until the valve has been inspected and tested by a qualified technician. This could indicate a failure in the internal mechanism or supply lines.