Rubson sanitary sealant - Trigger - White

It is designed to create waterproof and flexible seals for joints in bathrooms and kitchens, such as around sinks, bathtubs, and shower bases.

Hold the trigger and apply steady, even pressure while moving the applicator along the joint. Smooth the bead immediately after application with a wet tool.

This sealant is typically not designed to be painted over. For best results, ensure a neat application during use.

It adheres to a wide range of materials including ceramic, enamel, laminate, stainless steel, aluminum, and painted surfaces.

The sealant requires approximately 24 hours to fully cure, though touch-dry times may be shorter. Refer to the product packaging for specific curing times.

This product is specifically formulated for indoor sanitary applications in kitchens and bathrooms. It is not recommended for outdoor use.

Wipe away any uncured sealant immediately with a damp cloth. Once cured, it can be difficult to remove and may require mechanical means.

Ensure the trigger mechanism is fully engaged and try applying steady pressure. Check if the product has expired, as old sealant can harden.

The surfaces may not have been properly cleaned or dried. Remove the old sealant, clean the area thoroughly with a degreaser, and ensure it is completely dry before reapplying.

Practice on a piece of scrap material first. Apply steady, even pressure on the trigger and move at a consistent speed. Use a damp cloth or smoothing tool immediately after application to create a neat finish.

This can occur if the joint experiences significant movement or if the sealant was applied too thinly. Ensure adequate joint width and depth, and confirm the product's suitability for flexible joints.