Prima Plus Solder Ring Equal Tee - 42mm

No, the Prima Plus Solder Ring fitting has an integrated solder ring, eliminating the need for separate solder.

This fitting is designed for 42mm copper pipe.

Yes, Prima Plus Solder Ring fittings can be used for both water and gas installations, provided they comply with all relevant standards and regulations for gas work.

It is manufactured to EN 1254 standard, WRAS approved for drinking water, and Kite marked to BS standards.

Clean the outside of the pipe and the inside of the fitting socket with a fine abrasive cloth or pad to remove any dirt, grease, or oxidation.

The Kite mark indicates that the product has been independently certified to meet rigorous British Standards for quality and safety.

No, this is a solder-type fitting and requires copper pipe and traditional soldering techniques. It is not compatible with push-fit or compression systems.

Ensure pipe and fitting were thoroughly cleaned and deburred. Reheat the joint evenly and allow solder to flow. Check for adequate solder flow around the entire circumference. Ensure the correct pipe size (42mm) was used.

Verify sufficient heat is being applied to both the pipe and the fitting. Check that the correct type of torch and fuel are being used. Ensure the fitting is the correct size for the pipe and that there are no obstructions.

Reduce heat application slightly once the fitting is hot. Ensure you are heating evenly and not concentrating heat on one spot for too long before the solder is intended to melt.

Clean the fitting surface with fine abrasive cloth before heating. Store fittings in a dry, protected area. Minor surface oxidation typically does not affect performance if cleaned prior to jointing.