Soudal Soudafoam Window & Door (Genius Gun) - Soudal - 130580

The foam can be cut within 25 minutes. Full curing time depends on environmental conditions and gap size, but typically takes a few hours.

Yes, once the foam is fully cured, it can be painted over. Use a paint suitable for use with polyurethane foam.

The yield varies depending on the product, but it is a high-yield filler. Always estimate the gap volume and allow for expansion.

Use a foam cleaner or acetone to remove uncured foam. Be careful to avoid contact with skin and eyes.

The shelf life is typically 12 months from the production date if stored properly. Check the expiration date on the can.

Gun Grade requires a foam gun for application, providing precise control. Genius Gun is a hand-held version for easier use.

The surface should be dry for optimal adhesion. However, the cured foam is water-resistant.

Ensure the can is shaken well before use. Check the expiration date. The surface might be too cold. Ideally, the surface should be between +5°C and +30°C.

Clean the foam gun immediately after use with a foam gun cleaner. Remove the nozzle and clean it.

Apply the foam sparingly, filling only about half the gap, as it will expand. Ensure the application is done at the right temperature.

Ensure the surface is clean and dry. Use a primer if necessary, especially on difficult surfaces.