Lieber Silk White 2 Gang Outdoor Dimmer Switch - White

It is suitable for outdoor lights that use dimmable LED bulbs (up to 100W per gang) or Halogen/Incandescent bulbs (up to 250W per gang). Non-dimmable bulbs are not compatible.

IP rating signifies the level of protection against solid objects (like dust and dirt) and liquids (like water). This switch is designed to prevent ingress of such elements, making it safe for outdoor use.

This is an electrical device and should ideally be installed by a qualified electrician to ensure safety and compliance with regulations. Always switch off power at the mains before commencing any electrical work.

Clean the exterior with a soft, damp cloth. Avoid using harsh chemicals or abrasive cleaners that could damage the casing or the seal.

Each gang of the dimmer switch supports a maximum load of 100W for LED bulbs and 250W for Halogen/Incandescent bulbs.

The switch is designed for direct dimming of compatible bulbs. It does not have smart home connectivity features and is not designed to control smart bulbs directly unless they are specifically designed for trailing-edge or leading-edge dimmer compatibility and within the wattage limits.

Verify that the power supply to the circuit is connected and switched on. Check all wiring connections to ensure they are secure and correct.

This may indicate incompatible bulbs. Ensure you are using dimmable LED bulbs (within 100W per gang) or Halogen/Incandescent bulbs (within 250W per gang). Check that the bulbs are fully compatible with electronic dimmers.

Confirm that the connected lights are dimmable and within the specified wattage limits for the respective gang. Remove any non-dimmable loads.

Immediately turn off power. Inspect the rubber seal for damage or debris and re-seat it carefully. Ensure the casing is fully closed and secured. If damage is evident, the unit may need replacement.