Brake Hose - Borg & Beck - BBH6598

A brake hose is a flexible conduit that transmits hydraulic pressure from the rigid brake lines to the brake caliper or wheel cylinder, enabling the brakes to apply force to the wheels. It allows for suspension movement without stressing the rigid lines.

The BBH6598 is specifically designed for the front axle. Rear brake hoses often have different lengths, mounting points, and flexibility requirements. Always use the part specified for the correct axle.

Brake hoses should be inspected at every brake service. While there's no fixed interval, they are typically replaced every 5-7 years or sooner if signs of wear (cracking, swelling, leaks) are present, as rubber degrades over time.

M10x1 refers to the metric thread size. 'M10' indicates a major diameter of 10 millimeters, and '1' indicates a pitch of 1 millimeter between threads.

Brake system repairs are critical for vehicle safety. While DIY installation is possible, it requires specialized knowledge and tools, including proper bleeding techniques. Professional installation is strongly recommended to ensure safety and correct function.

The 360mm length is the specific measurement required to correctly route the hose from the chassis to the moving wheel hub assembly, allowing for full suspension travel without binding, kinking, or stressing the hose.

This often indicates air in the brake lines. The brake system needs to be bled properly. Ensure the new hose was correctly installed and the system was bled according to manufacturer specifications. Check for leaks at all connections.

Check that the threads are correctly engaged and tightened to the proper torque. Ensure the sealing surfaces are clean and free of debris. If the leak persists, the hose or the fitting it connects to may be damaged.

Verify that the hose is routed correctly and secured properly. Ensure the length is appropriate for the application. Incorrect routing or an incorrect hose length can lead to damage and premature failure.