Pro Taper Synergy Grips Black - Race Cut - Half Waffle - Single Density

While they can be installed on 7/8" handlebars, their race-specific design and soft compound are optimized for off-road racing and may not be ideal for all street riding applications.

The 'Race Cut' designation indicates a design tailored for competitive riding, often implying specific shaping or features that enhance performance and control under racing stress.

Basic tools like grip glue, a razor blade (to clean old grip residue), and wire cutters for tie-wire are recommended. No specialized mechanical tools are typically required.

Grip replacement frequency depends on usage and riding conditions. For competitive riders, inspecting them after every few races or at the end of a season is advisable. Look for signs of excessive wear, tearing, or loss of grip texture.

No, these grips are single-density and do not have features to accommodate heated handlebars. Using them with heated handlebars could damage the grip or interfere with heat transfer.

Single density refers to the grip being made from one uniform type of rubber compound. This differs from dual-density grips, which combine two different materials for varied feel and durability in different areas.

This is characteristic of the extra-supple compound designed for reduced fatigue. If a firmer feel is preferred, consider a different grip model or density.

Ensure proper grip glue application and cure time. Verify that the handlebar surface is clean and free of oil or debris. Use tie-wire for maximum security, especially in demanding conditions.

Ensure the handlebar is clean and free of obstructions. A small amount of grip glue or a specialized grip installation lubricant can aid in sliding the grips on.

Ensure the tie-wire is routed through the designated grooves and is not overtightened to the point of deforming the grip material excessively. Use appropriate gauge wire.