Fastrax 32dp 16T Steel Pinion Gear - FAST32-165
Not Available
Currently unavailable
Currently out of stock
This product is not available at the moment. Check back later.
Product Information
Full details
This guide is for radio control (RC) hobbyists and enthusiasts using the Fastrax 32dp 16T Steel Pinion Gear (FAST32-165). This gear provides reliable performance and durability for your RC models. Note that proper gear selection and mesh are critical for optimal performance and longevity of your RC vehicle.
All features
| Model Part Number | FAST32-165 |
|---|---|
| Brand | Fastrax |
Extended Product Information
FAQs
What is 32dp?
32dp refers to the gear pitch, which is a measurement used to determine the size and spacing of the gear teeth. It's crucial for compatibility with other gears.
What tools do I need to install this gear?
You will likely need a hex wrench or a small screwdriver to remove the old gear and install the new one. Check your RC model's manual for specific tool recommendations.
How often should I check the gear mesh?
Check the gear mesh regularly, especially after hard use or crashes. It's good practice to check it after every few runs.
What happens if the gear mesh is too tight?
If the gear mesh is too tight, it can cause binding, reduce speed, and generate excessive heat, which can damage the motor and gears.
Can I use this gear with any motor?
This gear is compatible with motors that have a 5mm shaft and are designed to work with 32dp gears. Always check the motor specifications and your RC model's manual.
How do I clean the gears?
Use a soft brush or compressed air to remove dirt and debris. Avoid using harsh chemicals or solvents.
What material is this gear made of?
The gear is constructed from durable steel.
What is the shaft size?
The shaft size is 5mm.
Troubleshooting
Gear is making excessive noise.
Adjust the gear mesh. If the noise persists, check for debris or damage to the gear.
RC car is slow or has reduced acceleration.
Check the gear mesh and ensure the gear is meshing correctly with the spur gear. Consider replacing a worn-out gear.
Gear stripped or damaged.
Replace the damaged gear with a new Fastrax 32dp 16T pinion gear.
Pros and Cons
Pros
- Durable steel construction.
- Precise gear pitch for efficient power transfer.
- Compatible with various RC models.
- 5mm shaft size provides a secure fit.
- From the reputable Fastrax brand.
Cons
- Requires proper gear mesh setup.
- May require shimming for optimal performance.
- Specific to 32dp gear pitch; not compatible with all RC systems.
- Steel gears can be heavier than other materials.
- Requires disassembly for replacement.
Setup, Compatibility & Care
- Compatibility: This gear is compatible with RC models that use a 32dp gear pitch and a 5mm motor shaft. Check your model's specifications before installation.
- Installation:
- Remove the old pinion gear from the motor shaft.
- Install the Fastrax 32dp 16T gear, ensuring it's properly aligned.
- Adjust the gear mesh (the gap between the pinion and spur gear) to prevent binding or excessive wear. Use a small piece of paper between the gears as a guide.
- Care: Regularly inspect the gear for wear and tear. Keep the gear clean and free of debris. Lubricate the gears as recommended by your model's manual to maximize lifespan.