Garden Furniture Oil - Clear - 1 Litre

Liberon Garden Furniture Oil is suitable for all exterior wood types, including teak, oak, pine, and more. It is ideal for garden furniture, decks, and other outdoor wooden structures.

Each coat of oil requires a minimum of 24 hours to dry before the next coat can be applied. The furniture should also be left to dry for at least 24 hours after the final coat before use.

The coverage is approximately 30m² per litre per coat. This can vary depending on the porosity and condition of the wood.

Yes, the surface must be clean, dry, and free from varnish or other finishes. If an old finish is present, it must be removed before application.

It is recommended to reapply the oil periodically, typically annually, or whenever the wood begins to look dry or faded. Regular maintenance ensures continued protection.

This product is specifically formulated for exterior use. For interior wood, please refer to Liberon's range of interior wood oils and finishes.

A tacky finish usually means excess oil was not removed. Ensure you wipe off all surplus oil with a clean, lint-free cloth after the recommended 20-minute penetration time. If it's already tacky, you might need to lightly sand and reapply, wiping more thoroughly.

This can happen if excess oil was not wiped off completely. Ensure all excess oil is wiped away thoroughly during the application process. If already applied, you may need to lightly sand the affected area and reapply, ensuring proper wiping.

Check that the wood surface is clean and dry. Existing sealants or heavily weathered wood might resist initial penetration. Ensure the product is shaken well and applied liberally. For very dry wood, a second coat after 24 hours might be necessary.

This usually indicates that the wood was not properly cleaned of mould or grime before application. Use Liberon Garden Furniture Cleaner to treat the affected area and remove the blackening, then reapply the oil after thorough drying.

This is typically due to not wiping off the excess oil after the penetration period. Wipe the surface again with a clean, lint-free cloth. If the stickiness persists, you may need to lightly sand the area and reapply, being careful to wipe off all excess.