Traffic Film Remover & Chassis Cleaner - SnowPro - 10L

While generally safe for most vehicle surfaces, it's always recommended to test a small, inconspicuous area first on matte finishes, as they can be more sensitive. Use a lower concentration and rinse thoroughly.

This product is designed for manual application via foam cannons, pressure washers, or bucket washing. It is not typically suitable for direct injection into automatic car wash systems without specific professional guidance and system compatibility checks.

For general traffic film, a dwell time of 3-5 minutes is usually sufficient. For heavier grime or tar, you can extend this slightly, but do not allow the product to dry on the surface.

For general vehicle cleaning, a dilution of 1:20 to 1:50 (product to water) is a good starting point. For heavily soiled chassis, a more concentrated mix like 1:10 might be needed.

Yes, as a powerful traffic film remover, it is designed to strip away heavy grime and road film, which can also remove or significantly degrade existing wax or sealant layers. This makes it ideal for pre-wash stages before applying new protection.

It is not recommended to mix this product with other cleaning chemicals, as doing so could create hazardous reactions or reduce the effectiveness of the TFR. Use it as directed, either on its own or as part of a multi-step cleaning process.

Ensure you are using the correct dilution ratio for foaming applications. Check that your foam cannon or lance is clean and functioning correctly. Try adjusting the dilution or water flow.

This usually indicates insufficient rinsing or the product drying on the surface. Rinse thoroughly with plenty of clean water immediately after the cleaning cycle. Avoid using in direct sunlight on hot panels.

Verify that the dilution ratio is appropriate for the level of soiling. For sensitive plastics or a lighter clean, use a more diluted solution (e.g., 1:50 or higher).

For extremely stubborn tar, a more concentrated solution or a dedicated tar remover may be necessary. Allow the TFR to dwell for a longer period (up to 10 minutes) before rinsing.