Connect Push Type Retainer - White - 25pc

They are commonly used for securing automotive trim panels, interior components, and light-duty industrial applications where a quick and secure fastening is needed.

This retainer is designed to fit into a hole with a diameter of 8.8 mm.

Yes, these push-type retainers are generally reusable if removed carefully without damage. However, repeated removal and reinstallation may eventually weaken their holding power.

The retainers are made from white nylon, which provides durability and resistance to certain environmental factors.

No, these retainers are best suited for light to medium-duty applications. For heavy-duty fastening, different types of hardware are recommended.

These dimensions are not standard for this type of fastener. Typically, dimensions refer to the head diameter and the length of the shaft. Given the product description, it's likely there is a typo in the provided dimensions; the 'head' likely refers to the top part of the retainer and the 'length' to the shaft, but the specific measurements provided (183mm x 97mm) seem unusually large for a standard push retainer fitting an 8.8mm hole. Please refer to the fitment hole size (8.8mm) for primary compatibility.

Verify that the hole size is exactly 8.8 mm. If the hole is too large, the retainer will not grip properly. If the hole is too small, it may be difficult to insert or may damage the retainer.

Ensure the hole is clean and free of debris. Check for any burrs around the hole that might impede insertion. Do not force the retainer; if it resists significantly, re-check the hole diameter and alignment.

This may indicate the hole size is too small or excessive force was used. Ensure the correct hole size is being used and apply firm, steady pressure during insertion. Replace with a new retainer.