Best current price£11.94from OnBuy.com
Shopping.co.uk recommended and popular offers
OnBuy.com£11.94Visit shop Dc24v Ip67 20W Waterproof Led Driver Power Supply Transformer~3348 5056756329051
Visit shop
B&Q£55.99Visit shop - Crystal Wall LightModern Wall Lamp Indoor With 3 Tiers CrystalsBlack & Gold Finish2Xe14 Luxury Crystal Sconce Light
Visit shop3 offers from £11.94 - £55.99
View price history by clicking the chart icon.
This 20W LED driver power supply transformer is designed for users needing reliable, waterproof power for 24V LED lighting and other DC devices, especially in outdoor or wet environments. Its key benefit is enhancing the lifespan and stability of connected LEDs through advanced protection mechanisms. A caveat is that installation accessories like cables and instructions are not included. Key features include IP67 waterproofing, constant voltage output, and comprehensive safety protections.
| Model Part Number | S0671114878 |
|---|---|
| Brand | LEDSone |
Yes, the driver has an IP67 waterproof rating, making it highly resistant to dust and water ingress, thus suitable for outdoor applications.
This LED driver has a maximum output power of 20 watts.
No, this driver provides a constant 24V DC output and is only compatible with devices specifically designed for 24V power supplies. Using it with 12V devices could damage them.
IP67 means the unit is protected against dust ingress and can withstand immersion in water up to 1 meter deep for 30 minutes.
No, the package does not include installation instructions, wiring cables, an on/off switch, or screws. These must be sourced separately.
It provides a stable, constant voltage output and includes protections against over voltage, short circuits, and overloads, all of which prevent damaging power fluctuations that can shorten LED lifespan.
Yes, the input voltage can be switched between AC 110V and AC 230V. Ensure it is set correctly for your local power supply before connecting.
Check that the AC input voltage is correctly set (110V/230V) and properly connected. Verify the DC output is connected with correct polarity to the LED lights. Ensure the total power consumption of the LEDs does not exceed the 20W limit of the driver.
Confirm the output voltage is stable at 24V DC. If using LED strips, ensure the wiring is adequate for the length and power draw. Check for loose connections at both the input and output terminals. The anti-interference function may be less effective if the unit is placed too close to strong electromagnetic sources.
Ensure the total load does not exceed the 20W capacity. Verify the unit is not installed in a completely enclosed space without any airflow, although it is designed for protection against over-temperature. Check for short circuits in the connected LED devices or wiring.
This could indicate an overload, short circuit, or over-voltage event. Inspect the connected devices and wiring for damage or faults. The protective mechanisms should have triggered; reset the power if necessary after addressing the fault.
Setup: This transformer requires careful wiring. Connect your AC power source (110V or 230V, selectable) to the input terminals and your 24V DC LED devices to the output terminals. Ensure correct polarity and secure connections. Due to the absence of included instructions and cables, basic electrical knowledge is recommended for safe installation.
Compatibility: Compatible with all low-voltage (24V) LED products that require a constant voltage power supply, including MR11, MR16 LED bulbs, most LED strip lights, CCTV cameras, and 3D printers. Verify the power requirements of your device do not exceed the 20W output.
Care: To maintain performance, ensure the unit is installed in a well-ventilated area if possible, though its waterproof design allows for exposed use. Periodically check connections for security. Cleaning can be done with a dry or slightly damp cloth; avoid harsh chemicals or immersing the unit in water.
