HUAWEI WATCH FIT 5 - Green

Use the magnetic charging cable provided. Align the charging pins on the cable with the charging contacts on the back of the watch. Connect the USB end of the cable to a power adapter or USB port.

Yes, the watch is designed to be water-resistant and suitable for swimming. However, it's recommended to rinse it with clean water after swimming in chlorinated or salt water and avoid exposure to hot water or steam.

It is compatible with smartphones running Android 6.0 or later, and iOS 9.0 or later.

Firmware updates are typically delivered through the HUAWEI Health app. Ensure your watch is connected to your phone and check for updates within the app's device settings.

SpO₂ monitoring measures the oxygen saturation level in your blood. This can provide insights into your respiratory health and overall well-being, especially during sleep or at high altitudes.

The watch uses its sensors to detect sudden, hard falls. If a fall is detected and you don't respond within a set time, it can automatically alert your designated emergency contacts with your location.

While the watch can track basic activities and display the time without a smartphone, many features like notifications, NFC payments, firmware updates, and detailed health data syncing require a connection to a paired smartphone via the HUAWEI Health app.

Ensure the watch is adequately charged. Connect it to the charger for at least 15 minutes and try again. Check that the charging contacts are clean.

Make sure the watch is worn snugly on your wrist, about one finger's width above your wrist bone. Clean the sensors on the back of the watch. Avoid excessive movement during readings.

Restart both your watch and smartphone. Ensure Bluetooth is enabled on your phone and that the watch is within range. Unpair and re-pair the device in the HUAWEI Health app.

Verify that NFC is enabled on the watch and in the HUAWEI Health app. Ensure your bank/card is supported for NFC payments in your region. Check if there are any pending app or firmware updates.

Try restarting the watch by pressing and holding the side button. If the issue persists, perform a factory reset via the watch's settings menu (this will erase all data).