Autotek Aerosol Spray Paint - Red - 300mL

This paint is an exact match for Audi Brilliant Red (LY3J, C8) and is compatible with Audi models manufactured between 2002 and 2016.

Yes, this paint is suitable for application on metal, glass fiber, and rigid plastic surfaces, provided they are properly prepared and primed.

The paint should be touch dry within 10-20 minutes after application. Full curing takes approximately 24 hours.

For best results, apply the paint in a temperature range between 15°C and 25°C (59°F to 77°F).

Yes, using a minimum of two coats of Autotek Red Primer is highly recommended for optimal adhesion and the best possible finish.

After each use, invert the aerosol can and spray for 2-5 seconds. This will clear the nozzle and prevent blockages from forming.

It is strongly advised to use this product only outdoors or in a very well-ventilated area due to the nature of aerosol paints and potential fumes.

Ensure the can is shaken thoroughly for at least 2 minutes. Check if the nozzle is partially blocked; if so, try clearing it by spraying upside down briefly after use. If persistent, the nozzle may need replacement or the can may be faulty.

The surface may not have been adequately cleaned or prepared. Ensure all contaminants like oil, wax, or rust were removed. Re-sanding and re-priming may be necessary before reapplication.

Verify the correct paint code (LY3J, C8) for your Audi model and year. Ensure sufficient coats have been applied and that the paint has fully cured, as color can deepen over time. Environmental conditions during application can also affect the final shade.

The spray distance may have been too close, or too much paint was applied in a single coat. Apply lighter coats from the recommended distance (15-25cm) and allow adequate drying time between applications.