Marshalls Keykerb Bullnosed Charcoal Kerb Pack - 125mm x 100mm x 127mm

The dimensions of each unit are approximately 125mm (height) x 100mm (width) x 127mm (length).

No, this specific product is a bullnosed *external* angle unit. Marshalls offers different Keykerb shapes for internal corners.

The product information typically specifies the number of units per pack. Please refer to the product listing or packaging for exact quantities.

Yes, laying the kerbs on a mortar bed is recommended for stability and longevity, especially for edging and corner applications.

While concrete can be cut, these units are designed to provide specific angles (external corners) to avoid on-site cutting. Cutting may affect the bullnosed finish and structural integrity.

Clean with water and a soft brush. For tougher stains, use a mild detergent and rinse thoroughly. Avoid abrasive cleaners.

They are designed to complement Marshalls Keyblok. Compatibility with other brands is not guaranteed in terms of alignment and aesthetic finish.

Check the mortar bed for consistency and ensure the sub-base was level. Minor adjustments may be possible by carefully tapping units with a rubber mallet before the mortar fully sets. For set mortar, re-bedding may be required.

Ensure the adjacent paving courses are laid precisely. The Keykerb external angle unit is designed for this, so check alignment of the paving before placing the kerb. Verify that no debris is obstructing a flush fit.

If color variation is noticeable, it is best to select units from the same batch for any visible section. Contact the supplier if the variation is significant and unacceptable for your project.

Gently scrub the affected areas with a stiff brush and water. For persistent growth, use a specialist patio cleaner suitable for concrete products, following the manufacturer's instructions, and rinse thoroughly.