FloPlast Solvent Weld Waste Coupling - 32mm - Grey

FloPlast SC250 solvent cement is recommended. Ensure you use a cement specifically approved for PVC-U waste systems.

No, this coupling is specifically designed for solvent weld waste systems and is manufactured to BS EN 1455. It is not intended for use with rainwater downpipes.

The push and twist action ensures an even distribution of the solvent cement over both surfaces, creating a stronger, more reliable bond.

Allow a minimum of 5 minutes to set before handling and a minimum of 12 hours to fully cure before testing with water or putting the system into use.

Always work in a well-ventilated area, away from heat sources and naked flames. Wear appropriate safety gloves and eye protection. Wash skin thoroughly if solvent cement comes into contact with it.

The Kitemark is a voluntary third-party certification mark that indicates the product has been tested and meets relevant British Standards (BS EN 1455 in this case), ensuring quality and reliability.

Yes, installation requires basic tools like a clean cloth, and potentially a pipe cutter if modifying existing pipework. The primary requirement is the correct solvent cement and adherence to the installation steps.

Ensure surfaces were clean and dry before application. Confirm correct type and amount of solvent cement was used. Allow full 12-hour curing time before testing under pressure. Ensure pipes were fully inserted into the fitting.

Check for any obstructions or damage on the pipe end or inside the fitting. Ensure correct pipe size is being used. If applying cement, ensure an even coat and be ready to join immediately after application.

Ensure you are working in conditions within the recommended temperature range for the solvent cement. For warmer conditions, work quickly; for colder conditions, ensure adequate curing time.