Scheppach Petrol Chainsaw - PCS38

The Scheppach PCS38 typically requires a 40:1 fuel-to-oil ratio using unleaded gasoline and a high-quality 2-stroke engine oil. Always refer to your owner's manual for the exact specification.

The PCS38 features tool-free chain tensioning. Locate the tensioning knob or screw (usually on the side or front of the bar housing) and rotate it to tighten or loosen the chain. The chain should be snug enough not to sag but still be able to be pulled around the bar by hand.

Use a specialized bar and chain oil. This type of oil is designed to adhere to the chain and provide lubrication. Do not use motor oil or the fuel/oil mixture.

Sharpen the chain whenever it starts to cut slowly or roughly. This can depend on usage, but a general guideline is after every 10-15 minutes of cutting time, or when you notice a loss in cutting performance.

While the PCS38 is capable of cutting branches and smaller trees, it is primarily designed for firewood preparation and pruning. For significant tree felling, a larger or more specialized saw might be more appropriate. Always follow safe felling practices and local regulations.

The air filter should be cleaned regularly, especially in dusty conditions. Gently tap it to remove loose debris. If it appears heavily soiled or damaged, it should be replaced.

Warranty information varies by region and retailer. Please consult your product documentation or the retailer where you purchased the chainsaw for specific warranty details.

Check fuel mixture and level. Ensure the spark plug is clean and properly gapped. Verify the choke is set correctly for starting. Check that the ignition switch is in the 'on' position.

The chain may be dull and require sharpening. Check chain tension; it should be snug but still allow manual movement. Ensure the chain lubrication system is functioning and the oil reservoir is full.

The air filter may be clogged; clean or replace it. Check the fuel mixture for correct ratio and freshness. Ensure the spark arrestor screen in the muffler is clean.

Ensure all components, especially handles and guards, are securely tightened. Check the condition of the anti-vibration elements. If vibration persists, contact customer support.

Re-tension the chain properly. Check for damage to the bar or chain. Ensure the bar is correctly seated and the chain is not overtightened or too loose.