McAlpine Compression Ring - T13-ISO - 1 1/2"

The isolating sleeve prevents direct contact between dissimilar metals (like copper pipe and a brass fitting), which significantly reduces the risk of galvanic corrosion, thus preventing premature failure of the joint.

This ring is designed for use with standard compression fittings that consist of a compression nut and a compression ferrule, specifically on 1 1/2 inch pipes.

The McAlpine T13-Iso is designed for 1 1/2 inch nominal bore pipes.

You will need standard plumbing wrenches to tighten the compression nut onto the fitting body. Ensure the tools are the correct size for the nut.

A proper seal will not show any signs of weeping or dripping water under normal operating pressure. After tightening, you can carefully inspect the connection point for any moisture.

This product is designed for water plumbing applications. It is not intended or rated for use on gas lines.

The compression ring itself is made of brass, and it features an isolating sleeve to prevent corrosion.

Ensure the compression nut has been adequately tightened. Check that the pipe is correctly inserted and that the ferrule and ring are properly seated. Inspect the pipe end for damage or distortion. If the leak persists, it may be necessary to dismantle the fitting, inspect the components for damage, and reassemble, ensuring correct alignment.

Verify that you are using the correct size ring for a 1 1/2 inch pipe. Ensure the pipe end is clean, free of debris, and not deformed. A slight chamfer on the pipe end can aid in insertion.

Ensure the isolating sleeve of the T13-Iso ring is correctly positioned between the pipe and the fitting components. If corrosion is still occurring, re-evaluate the materials being joined and ensure the isolating sleeve is functioning as intended. The sleeve is designed to prevent galvanic corrosion, but severe or unusual conditions may require further consultation.