DT Swiss Front Hub Conversion Kit - 15 mm x 100 mm
Not Available
Not Available
Currently unavailable
Currently out of stock
This product is not available at the moment. Check back later.
Product Information
Full details
The DT Swiss Front Hub Conversion Kit is an essential upgrade for cyclists looking to adapt their existing 2011 or newer DT 240 Center Lock Disc hubs to modern 15mm x 100mm thru-axle standards. This kit is perfect for riders upgrading their forks or moving components between bikes, offering a precise, factory-engineered fit. The primary caveat is that it is exclusively designed for hubs with an 18mm outer diameter axle, so users must verify their current hub specifications before installation to ensure compatibility.
All features
| Brand | DT Swiss |
|---|
Extended Product Information
FAQs
Will this work with a 6-bolt rotor hub?
No, this kit is designed specifically for DT 240 Center Lock Disc hubs.
Do I need special tools for the installation?
Generally, DT Swiss end caps can be removed and installed by hand or with simple soft-jaw pliers.
Is this kit compatible with DT 350 hubs?
No, this kit is specifically engineered for the DT 240 series hub.
Can I use this for a 110mm Boost spacing fork?
No, this kit is designed for 100mm spacing only.
How do I know if my axle is 18mm?
You can measure the outer diameter of the existing axle protruding from the hub shell using a digital caliper.
Troubleshooting
End caps do not fit onto the axle
Verify your hub has an 18mm outer diameter axle. If the hub is older than 2011, this kit will not fit.
Wheel feels loose in the fork after installation
Ensure the end caps are fully seated and that the fork thru-axle is torqued to the manufacturer's recommended specification.
Pros and Cons
Pros
- High-quality factory manufacturing
- Easy conversion for specific DT Swiss 240 hub models
- Maintains hub structural integrity after modification
- Cost-effective alternative to purchasing new wheelsets
Cons
- Limited compatibility only for 2011+ DT 240 Center Lock hubs
- Requires specific 18mm outer diameter axle check
- Not compatible with non-Center Lock disc hub variants
Setup, Compatibility & Care
To install the kit, remove your existing end caps and slide the new 15mm thru-axle conversion caps into place. Ensure the hub shell is clean and free of debris before insertion.
Compatibility Note: This kit is strictly for 2011 and newer DT 240 Center Lock hubs featuring an 18mm outer diameter axle. Always confirm your axle diameter with a caliper if you are unsure of your hub's production year. To maintain the kit, lightly grease the internal O-rings of the end caps during annual service to ensure smooth installation and weather resistance.