JCP CONSTRUCTION PRODUCTS Shield Anchors Projecting Bolt - Zyp - M10 x 30mm - Gold

This shield anchor is designed for solid materials such as concrete, solid brick, and natural stone.

The projecting bolt has an M10 thread size.

Yes, you will need a drill with appropriate masonry bits for drilling the hole and standard wrenches for tightening the nut.

Refer to the product packaging for the exact recommended drill depth for the M10 x 30mm anchor. It is crucial to drill to the specified depth for optimal performance.

The durable materials used offer good resistance, but for prolonged outdoor exposure or corrosive environments, additional protective measures or specific outdoor-rated fixings might be necessary.

The exact holding capacity depends on the specific base material, hole preparation, and installation torque. Always consult the technical data sheet provided by JCP CONSTRUCTION PRODUCTS for detailed load ratings.

To remove, unscrew the nut completely. You may need to use pliers or a wrench to grip the shield and pull it out, or in some cases, it may require drilling out.

Ensure the hole was drilled to the correct diameter and depth. Verify the base material is solid and suitable for this type of anchor. Check that the shield anchor is fully expanded within the hole.

Confirm the hole diameter matches the anchor specifications. Clean the hole thoroughly of any debris. If resistance is still high, re-drill the hole slightly larger if permissible by the anchor's specifications, or use a different fixing method.

The anchor may not be fully engaged with the base material. Try backing off the nut slightly, ensuring the shield is seated correctly, then re-tighten. If it continues to spin, the anchor may need to be removed and replaced.