St Helens Micro Sprinkler - Mist Spray Set

Micro-irrigation is a method of watering that delivers water slowly and precisely directly to the plant's root zone, often through fine mists or drips. This conserves water and is more efficient than traditional sprinklers.

This system significantly reduces water usage by minimizing run-off, evaporation, and wind drift compared to conventional watering methods, leading to increased water use efficiency.

The kit includes everything you need to get started, such as tap connectors, ground spikes, drip emitters, and 10 meters of tubing.

While the kit includes 10 meters of tubing, you may be able to purchase additional compatible tubing and connectors separately to extend the system's reach, depending on availability and water pressure.

Yes, the mist spray is ideal for delicate plants, seedlings, and general irrigation. The precise delivery is beneficial for most garden plants.

The St Helens Micro Sprinkler - Mist Spray Set comes with a 12-month guarantee.

This system is primarily designed for soil-based irrigation and cooling. It is not intended for hydroponic systems, which require different setups.

The kit includes a tap connector that is designed to fit standard outdoor faucets. Simply screw the connector onto your faucet before attaching the main tubing.

Ensure the tap is turned on fully. Check that the tubing is securely connected to the tap connector and that all emitters are properly attached. Verify that there are no kinks or blockages in the 10-meter tubing.

Adjust the position of the mist spray emitters. Ensure the tubing is laid out evenly and not stretched too tightly. In windy conditions, mist effectiveness will naturally be reduced; consider using during calmer periods.

Check the main water supply pressure. Ensure the tap connector is not restricting flow. If using multiple emitters, ensure the water pressure is sufficient for the number of outlets.

Gently remove the clogged emitter and rinse it under running water. Use a small, soft brush or pin to dislodge any debris. If the issue persists, consider replacing the emitter.