Best current price£144.59from www.pond-planet.co.uk
Shopping.co.uk recommended and popular offers
www.pond-planet.co.uk£144.59Visit shop Oase Filtral 5000 Replacement Uv And Pump
Visit shop1 offer from £144.59
View price history by clicking the chart icon.
The Oase Filtral 5000 Replacement UV and Pump is an essential maintenance solution for pond owners using the Filtral 5000 filtration system who need to restore optimal water clarity and circulation. This replacement unit effectively integrates both pump and UV clarifier functions to tackle green water and debris. Please note that this component is strictly limited to the Filtral 5000 model and requires careful installation to ensure water-tight seals are maintained during the replacement process.
| Model Part Number | 35874 |
|---|---|
| Brand | Oase |
No, this unit is specifically designed and calibrated for the Filtral 5000 model (MPN 35874).
No, the installation is straightforward and requires standard hand tools or simply following the locking ring instructions on the housing.
For optimal algae control, it is recommended to replace the UV lamp once per season or every 8,000 hours of use.
Please refer to your local Oase distributor's documentation as warranties are subject to regional purchase and registration terms.
No, this pump is intended for fully submerged use only; running it dry will cause immediate damage to the motor.
The replacement unit typically includes the necessary cable for connecting to the existing electrical housing of your Filtral system.
Check the intake strainer for blockages and ensure the impeller is free of debris or calcium deposits.
Verify that the UV bulb is functioning correctly; replace the bulb if it has been in operation for more than 8,000 hours.
Check that the impeller shaft is properly seated and that no pebbles or large grit are lodged inside the pump chamber.
To install this replacement, first ensure the power supply is disconnected. Carefully remove the existing housing from your pond, unscrew the cover, and disconnect the old pump and UV module. Ensure all O-rings are clean and lubricated before placing the new unit into the housing to guarantee a waterproof seal. Always check the electrical connections for moisture before reconnecting to the power source. For care, keep the intake clean of heavy debris to prevent premature wear on the pump impeller and replace the UV bulb annually or as performance dictates to maintain maximum efficiency.
