B2C Compression Fitting Straight Adaptor Reducer - 20mm 1" BSPF PN16

This fitting is rated to PN16, which corresponds to 16 bar or approximately 232 psi for cold water systems.

No, this fitting is specifically designed and rated for cold water systems only. It is not suitable for hot water applications.

The 20mm side is designed to connect to standard 20mm MDPE (Medium Density Polyethylene) pipe, commonly used for water supply.

BSPF stands for British Standard Pipe Female. This indicates the threaded connection is designed to accept a male BSP thread and has a specific thread form and pitch standard.

No special tools are required. You will need two wrenches (e.g., pipe wrenches or adjustable spanners) to tighten the compression nut, but no solvents, primers, or heat are necessary.

Ensure the pipe is cut square, clean, and fully inserted. Tighten the compression nut sufficiently according to standard practice for compression fittings to compress the ferrule onto the pipe and create a seal.

Check that the MDPE pipe was cut square and inserted fully into the fitting. Ensure the compression nut and ferrule were correctly positioned and tightened sufficiently. The pipe may be damaged or out of round; try re-cutting the pipe or using a repair insert if necessary.

Ensure the end of the 20mm MDPE pipe is not deformed. If it is, trim off the damaged end. Make sure the compression nut and ferrule are slid back sufficiently to allow full pipe insertion.

Ensure the threads are clean and free of debris. If the pipe is very stiff, slight warming with a heat gun (used cautiously and not in excess) might help make it more pliable, but this is rarely necessary for standard MDPE.