Everbuild Anchorset Spare Mixer Nozzle - Nozzle No. 4, 215mm

This Nozzle No. 4 is designed specifically for Everbuild Anchorset 380P, Anchorset 150, and Anchorset 300 adhesive cartridges.

The nozzle should be replaced when it becomes blocked, hardened, or if you notice inconsistent adhesive mixing and application. It is a consumable item.

Yes, the nozzle can be cleaned and reused if done immediately after use and if the cleaning is thorough. However, hardened adhesive residue can affect performance, and replacement may be necessary.

This mixer nozzle has a length of 215mm.

The Nozzle No. 4 is supplied in packs of 25 per outer.

The mixer nozzle ensures that the two-component parts of the Anchorset adhesive are properly mixed as they are dispensed, which is critical for achieving the correct chemical reaction and achieving full bond strength.

Ensure the nozzle is securely attached to the cartridge. Check if the nozzle is blocked or hardened; if so, replace it with a new one. Verify compatibility with the specific Anchorset adhesive being used.

This could indicate improper mixing. Ensure the nozzle is clean and functioning correctly, or replace it. Verify that the correct mixing ratio was achieved during dispensing.

Check for any adhesive residue on the cartridge threads or the nozzle. Clean both before attempting to attach or remove. Do not force the nozzle; if it's cross-threaded or damaged, replace it.