Primaflow Endfeed Tap Connector Bent - 22mm x 3/4"

Yes, it is WRAS approved for potable (drinking) water and suitable for both hot and cold water systems. Always check local regulations for specific gas installations.

WRAS approval means the product has been rigorously tested and meets the high standards set by the Water Regulations Advisory Scheme for use in contact with wholesome water supplied in the UK.

While manufactured to high standards, always confirm that this specific fitting is certified and appropriate for the type of gas and operating pressures required by your local gas safety regulations before use.

The Kite Mark is a voluntary British Standard certification mark, indicating that the product has been tested and certified by an independent body to meet specific quality and safety standards.

You will need soldering equipment (torch, solder, flux), pipe cutters, and potentially a pipe reamer or deburring tool.

For general cleaning, use a damp cloth. Avoid abrasive cleaners or solvents that could damage the copper or any protective finishes.

Ensure pipe and fitting are clean, dry, and free of oxidation. Apply flux evenly. Ensure adequate heat is applied to the fitting, not just the pipe.

The joint may not have been soldered properly. Draining the system and re-soldering the connection is recommended. Ensure the pipe was fully inserted before soldering.

Check that you are using the correct size pipe (22mm) and that the pipe end is not deformed. Use a pipe reamer to ensure a clean, round edge if necessary.