CRC Belt Conditioner - 7.5 Wt Oz
Not Available
Not Available
Currently unavailable
Currently out of stock
This product is not available at the moment. Check back later.
Product Information
Full details
This CRC Belt Conditioner is designed for automotive technicians and DIYers seeking to eliminate belt squeaks and extend the lifespan of all belt types, including serpentine, flat, and V-belts. Its primary benefit is preventing slippage and glazing caused by oil, grease, and wear, ensuring optimal power transfer and reducing the need for premature belt replacement. A key consideration is that this product is not VOC compliant for California and OTC markets.
All features
| Model Part Number | 05350 |
|---|---|
| Brand | CRC |
Extended Product Information
FAQs
What types of belts can I use this on?
CRC Belt Conditioner is suitable for all types of belts, including serpentine, flat, and V-type belts.
How often should I apply belt conditioner?
Application frequency depends on belt condition and environmental factors. Apply when you hear squeaking or notice slippage. Regular inspection is recommended.
Can this product be used on power transmission belts in industrial machinery?
Yes, it is effective on various belt types used in industrial applications to prevent slippage and wear.
Is this product safe for rubber belts?
Yes, the formula is designed to condition and protect rubber belts without causing damage.
What does 'VOC Compliant' mean in relation to this product?
VOC (Volatile Organic Compound) compliance refers to air quality regulations. This specific product is not compliant with VOC standards in California and other Over-The-Counter (OTC) regulated areas.
Will this conditioner stop belt noise caused by a bad pulley bearing?
No, this product addresses noise originating from the belt itself (squeaking, slipping). Noise from worn pulley bearings will require replacement of the bearing.
Troubleshooting
Belt continues to squeak after application.
Ensure the belt was clean before application. Reapply a thin, even coat. If squeaking persists, the belt may be severely glazed, worn, or damaged, and may require replacement.
Product overspray on other engine components.
Wipe away any overspray immediately with a clean cloth. Avoid spraying directly onto pulleys or tensioners, as this can cause slippage.
Belt feels excessively slippery after application.
An overly heavy application may cause temporary slippage. Allow the belt to run for a few minutes to dissipate excess product. If the issue persists, clean the belt with a degreaser and reapply sparingly.
Pros and Cons
Pros
- Addresses common belt squeaking issues.
- Extends the operational life of various belt types.
- Improves belt grip and reduces slippage.
- Cleans belt surfaces, removing performance-hindering contaminants.
- Versatile use across different belt configurations.
Cons
- Not VOC compliant for California and OTC markets.
- Requires proper application to avoid overspray.
- Effectiveness may vary based on the severity of belt damage.
Setup, Compatibility & Care
Setup: Shake the can well before use. Apply a light, even coat to the ribbed or flat side of the belt while the engine is running and the belt is in motion. Ensure the spray nozzle is held at an appropriate distance (refer to can for specifics) to avoid overspray.
Compatibility: This product is designed for use on all common belt types, including serpentine, flat, and V-type belts found in automotive, industrial, and agricultural applications.
Care: Store the can in a cool, dry place away from direct sunlight and heat sources. Keep out of reach of children. Ensure the nozzle is clear after use.