Knipex Diagonal Side Cutter - 160mm

These cutters are designed for cutting plastic sprues from molded components and soft materials like lead. They are not suitable for hard wires or metals.

Non-bevelled edges mean the cutting surface is flat, allowing for a very close, nearly flush cut on plastics. This prevents leaving a sharp stub when trimming sprues.

The cutting length is approximately 16 cm (6.3 inches).

Yes, they are suitable for trimming soft lead wires and plastic components in electronics assembly where precision is needed.

Keep them clean, dry, and occasionally lubricate the joint with light machine oil. Store them away from moisture.

Knipex typically offers a manufacturer's warranty against defects in material and workmanship. Specific warranty details may vary by region and retailer.

These cutters are specifically designed for plastics and soft lead. Attempting to cut hard wire may damage the cutting edges and is not recommended.

Inspect the joint for debris or damage. Clean the joint and lubricate with light machine oil. If the edges are bent or damaged, the tool may need replacement.

Clean the pivot point and apply a small amount of lubricant. Ensure no material is lodged in the mechanism.

Ensure you are cutting close to the component and that the material is within the tool's capacity. The non-bevelled edges are designed for specific types of cuts; ensure the material is suitable for this type of cutting action.