Shopping.co.uk

Hengst Engine Oil Filter - H90W01

Hengst Engine Oil Filter - H90W01

Ensure optimal engine performance with this high-quality Hengst oil filter, part number H90W01. En...

Best current price£7.26from Blueperry agriculture (UK)

Best offers

Shopping.co.uk recommended and popular offers

All Offers

11 offers from £7.26 - £17.72

View price history by clicking the chart icon.

Blueperry agriculture (UK)Hengst Oil Filter H90w01
Free delivery in 1–3 days
£7.26
Visit shop
eBayHENGST Spin-On Oil Filter H90W01
Free delivery in 1–3 days
£9.32
Visit shop

Product Information

Full details

The Hengst H90W01 oil filter is designed for automotive enthusiasts and DIY mechanics who prioritize engine longevity and OE-grade filtration. This high-quality spin-on filter delivers reliable debris removal and consistent oil flow, ensuring your engine runs smoothly under various driving conditions; however, potential buyers must verify specific vehicle compatibility through a parts catalog, as physical measurements like thread pitch and gasket diameter are critical for a proper seal.

All features

Model Part NumberH90W01
BrandHengst

Extended Product Information

FAQs

How often should I replace my Hengst oil filter?

It is recommended to replace the oil filter during every oil change, typically every 5,000 to 10,000 miles depending on your vehicle manufacturer's guidelines.

Can I use this filter if my car is not listed on the compatibility chart?

Do not install if it is not explicitly compatible. Using a filter with the incorrect thread size or gasket diameter can cause catastrophic oil loss.

Should I pre-fill the filter with oil before installing?

If the filter is mounted vertically, pre-filling with a small amount of oil can help achieve oil pressure faster, though it is not strictly required.

What does the 3/4-16 UNF specification mean?

This refers to the thread size and pitch; 3/4 refers to the diameter in inches, and 16 UNF refers to the number of threads per inch.

Does the filter come with a pre-lubricated gasket?

No, you should always apply a small film of fresh engine oil to the gasket manually before installation to ensure a proper seal.

Troubleshooting

Oil leaking from the filter base after installation

Check if the old filter's gasket was left on the engine block or if the new filter was cross-threaded during installation.

Difficult to remove the filter during the next change

Ensure you only hand-tighten the filter upon installation; do not use a wrench to overtighten.

The filter does not screw onto the mount

Verify that the thread size is 3/4-16 UNF and that there is no debris in the mounting hole.

Pros and Cons

Pros

  • Meets or exceeds OE manufacturing standards
  • Reliable debris filtration for extended engine life
  • Standard 3/4-16 UNF thread for broad compatibility
  • Durable housing construction for high-pressure environments

Cons

  • Requires manual verification of measurements for specific vehicles
  • Not universal; must match dimensions exactly
  • Professional installation recommended if inexperienced with oil changes

Setup, Compatibility & Care

Before beginning installation, verify that the H90W01 dimensions—76mm outer diameter, 62mm inner diameter, 79mm height, and 3/4-16 UNF thread—match your vehicle's existing component.

  1. Ensure the engine is cool to prevent burns.
  2. Remove the old filter using an appropriate strap wrench.
  3. Clean the mounting surface on the engine block to remove residual gasket material.
  4. Apply a thin layer of fresh motor oil to the new filter's rubber gasket.
  5. Hand-tighten the new filter until it contacts the base, then tighten an additional 3/4 turn.
  6. Start the engine and inspect for leaks immediately.

Price History

DatePrice
Visit shop