Ulti-Mate Stick-Fit Woodscrews Tub 4.0 x 50mm (800pk) - Gold

The Stick-Fit system is designed to keep the screw securely engaged on the driver bit, allowing for stable, one-handed installation. This significantly improves ease of use and speed, especially in challenging positions.

Yes, the drive system is 100% compatible with standard POZI and Phillips driver bits. However, using the included Stick-Fit driver bits will provide the optimal experience and enable one-handed installation.

They are suitable for hardwood, softwood, and man-made timber boards such as MDF, plywood, chipboard, and OSB, as well as sheet metal.

The Type-17 'slash' point is designed to drive through the hardest timber, often eliminating the need for pre-drilling. However, for extremely dense hardwoods or near edges, a small pilot hole may still be beneficial.

The wax lubricant reduces the friction and torque required to drive the screw into the material, making installation faster, easier, and less demanding on your tools and your body.

Each Trade Tub contains 800 Ulti-Mate Stick-Fit Woodscrews (4.0 x 50mm) and 2x high-quality Stick-Fit driver bits.

The screws feature a gold finish and a double-angle self-countersinking head. The head is designed to sit flush, so the finish will be visible on the surface unless it is subsequently covered or painted.

Ensure you are using the correct type of driver bit (POZI or Phillips) and that it is fully engaged with the screw head. If using standard bits, ensure they are not worn. For best results, use the included Stick-Fit driver bits.

Confirm the material is not excessively dense or obstructed. Ensure the drill is perpendicular to the surface. For one-handed installation, ensure the screw is properly seated on the driver bit.

While the Type-17 point is designed for hard timber, extremely dense woods may still benefit from a small pilot hole. Ensure the drill bit for the pilot hole is slightly smaller than the screw's core diameter.

Ensure the drill is not set to an overly high speed for the material, which can cause the head to sink too deep or tear the surface. The double-angle head should naturally countersink.