Best current price£354.99from B&Q
Shopping.co.uk recommended and popular offers
B&Q£354.99Visit shop B&Q - 18V Xr Dcf892P2T Brushless 1/2 High Torque Wrench Detent2X 5Ah Kit
Visit shop1 offer from £354.99
View price history by clicking the chart icon.
This DeWalt 18V XR Brushless 1/2" High Torque Wrench is designed for professionals and serious DIYers needing to remove stubborn fasteners in tight spaces. Its key benefit is delivering exceptional torque in a compact form factor, making difficult jobs more manageable. A potential caveat is its higher torque output, which requires careful use to avoid overtightening or damaging fasteners.
| Model Part Number | DCF892P2T-GB |
|---|---|
| Brand | DeWalt |
Breakaway torque (1152 ft-lbs) is the maximum torque the wrench can apply to loosen a stuck fastener. Fastening torque (813 Nm) is the maximum torque it applies when tightening.
Mode 1 (Low) is for delicate tasks or starting fasteners. Mode 2 (Mid) offers intermediate power. Mode 3 (High) provides full power for breaking loose stubborn fasteners. The Precision Wrench feature (in specific modes) helps prevent overtightening.
This wrench is designed for 1/2" impact sockets. While standard sockets might fit, using impact-rated sockets is highly recommended for durability and safety due to the high torque output.
Brushless motors are more efficient, provide longer runtime per charge, extend tool life by reducing wear, and allow for a more compact tool design compared to brushed motors.
Wipe the exterior with a dry or slightly damp cloth. Ensure the tool is switched off and the battery is removed before cleaning. Avoid using harsh chemicals or submerging the tool in water.
The kit includes the DeWalt DCF892N-XJ wrench, two 5Ah 18V XR batteries (DCB184), one DCB115 charger, a TSTAK compatible box, and nine 1/2" impact sockets (8mm, 10mm, 12mm, 13mm, 14mm, 15mm, 17mm, 18mm).
The LED light has a delay feature for continued illumination after trigger release. You can adjust its brightness by holding down the mode button for a few seconds until the desired level is reached, or turn it off completely by holding it longer.
Ensure the battery is properly seated and charged. Check battery contacts for dirt or damage. Try a different charged battery.
The battery may be low; recharge it. Check the socket for proper fit and ensure it's fully seated on the anvil. Inspect for any obstructions in the tool's mechanism.
Verify the socket has a compatible 1/2" drive. Ensure the detent pin is extending correctly and the socket is fully engaged. Clean the anvil and socket opening if debris is present.
Check if the LED brightness control has been adjusted to a low setting. Ensure the battery has sufficient charge. If the LED is damaged, contact customer support.
Setup:
Compatibility:
Care:
